Tiny Peg Circus, and it was time for those little performers to have a means of reliable transportation.
The wagon is just the right size to hold six members of the circus. For safety reasons, no one wanted to ride with the lions, so I constructed a little cage to tag along with the wagon. I'll show you how that was made at the end of this post.
Before assembling the wagon, I painted the body red, and the front and back pieces brown. The front seat was painted black, and given tiny gold "buttons", tiny circles which came from Dazzles gold stickers. Some striped paper went behind the seat, and lots more of the Dazzles stickers were applied around the window and doors and along the roof line. Metal stars, leaves, and filigree pieces add a lot of circus glitz.
The back of the wagon also has some stripes, plus a "wooden" painted platform that is just the right size to carry the strong man's barbells.
Here's a view of the back, without the barbells.
The lion cage is tiny, but large enough to comfortably carry a couple of felines. The cage was constructed with cardboard and part of a set of chipboard gates. Those gates made the perfect fancy bars for the cage.
To make the cage, use the smaller gates from the set. Remove the long side of the gate, seen on the left gate below. Figure out how large you want your cage to be. The walls of this one are 2 3/8" tall, and the front and back are 1 5/8" wide. You'll need four slim pieces to fit on each side of the bars for the front and back of the cage; these are 2 3/8" tall by 3/8" wide.
Paint the front and back bars of the gate gold with a paint pen, and paint the remaining cardboard red. Using Aleene's Tacky Glue, glue the narrow pieces right up against the bars, and then glue on the front and back at 90 degree angles. Working quickly, glue the bottom of the cage into place. Using an x-acto knife, carefully cut the bars flush with the bottom of the cage. Keep the part you cut off; you'll use that later. Attach the back of the cage, which consists of the bars with the thin strips attached, and then cut those bars off, again, flush with the bottom of the cage.
Using the gate parts you just trimmed off, cut the excess bars off as shown below, and then remove one of the finials so there are six remaining. These will now fit the front and back of the wagon. Glue into place along the tops.
Glue into place along the tops, as shown below. Wrap a Dazzles sticker around the top of the bars and the bottom of the cage, and glue stars on the front and back corners. Use E6000 to attach the tiny ring handle, decorate the back, and add a flag if you're feeling festive.
To attach the wheels, add a piece of cardboard to the bottom that's slightly smaller than the bottom itself. This will help stabalize the included rounded pieces that will hold the axles. Glue them in place as shown. Thread the axles through the holes, and put the wheels on. If the wheels tend to slide around, take some masking tape and roll it around the axle. That will keep the wheels in place. At the left of this photo, you can see the trailer hitch. It's simply a piece of cardboard with a hitch fastener punched through one end.
I hope you enjoyed seeing my circus wagon even half as much as I enjoyed making it. Let's all wave goodbye to the circus as it leaves forever.
For a complete list of supplies, click here.